M1 Dealer Site  

Any term All terms

Main Menu
Bulletin Board (Forums)
Site Search
Downloads **
Email Elk Tech Support
M1 Training Videos
RP Training Videos
XEP Training Videos
XSP Training Videos
Webinar Training Videos
Go to Main Elk Website

View Topic
Forums :: ELK-RM "Software for User Remote Control" :: ASCII command EE

| Reply Reply |
ASCII command EE
Posted by RichardNaninck on 11/02/2009 05:00 AM

Yesterday I upgraded my ELK M1G firmware to 4.5.20. I came from 4.4.12 so now I get the ASCII command EE which should display Entry/Exit times for starting and expiring. The EE command does show up in my logs however the length is wrong. I get 0F EE 1 0 000 000 00 1F which is one byte short. I would expect something like 0F EE 1 0 000 000 2 00 [CC] after arming to Stay. Since I get 9 zero's I can't really tell which byte is missing. The Length is correct according the RS232 Protocol but in real time the message I get is 1 byte short! I did a search, but didn't find anything usefull. Is this a known bug or am I missing something like an RP setting which I should do after an update?

| Reply Reply |