M1 Dealer Site  
Search

Any term All terms

Main Menu
Home
FAQs
Bulletin Board (Forums)
Site Search
Downloads **
Email Elk Tech Support
M1 Training Videos
RP Training Videos
XEP Training Videos
XSP Training Videos
Webinar Training Videos
Go to Main Elk Website

View Topic
Forums :: ElkRP "Software for Installer Programming" :: alarm info in email

| Reply Reply |
alarm info in email
Posted by jgalu on 10/02/2009 12:00 PM

Is it possilbe when the M1G sends an email notice about an alarm that the system add the alarm info ....... same as what it alreadys does for the central station.

Re: alarm info in email
Posted by bradweeks on 10/02/2009 12:06 PM

This feature request is on ELK Engineering List for consideration but currently not available.

Re: alarm info in email
Posted by SamRod on 04/22/2010 07:57 PM

This is possible but only for up to 16 zones. Here is my solution. In the XEP setup the first five emails to be you@somewhere.com (yes all the same email addresses.) then in the Message (this is the key point) say #1 is: "Front door opened at your location ALARM NOTICE, #2 is: "Back door opened at your location ALARM NOTICE, #3 is: "Motion at bay window opened at your location ALARM NOTICE, #4 is: "Garage door opened at your location ALARM NOTICE, #5 is: "Fire Alarm sensor 3 Hallway at your location ALARM NOTICE, Then in your rules just setup a rule for each zone/sensor your concerned with if its the front door? If front door becomes unsecure And Alarm is Armed then send email#1 If the Smoke sensor goes active? If Hallways sensor active then send email#5 I hope you understand my solution this WILL work for up to 16 scenerios due to the XEP's 16 email limit. Sam

| Reply Reply |

What's Related
These might interest you as well
FAQ

Form Generator

Web Pages