M1 Dealer Site  
Search

Any term All terms

Main Menu
Home
FAQs
Bulletin Board (Forums)
Site Search
Downloads **
Email Elk Tech Support
M1 Training Videos
RP Training Videos
XEP Training Videos
XSP Training Videos
Webinar Training Videos
Go to Main Elk Website

Q Can the CADDX wireless receiver be connected back to a keypad or does it have to be mounted at the panel?
A: The Caddx NX receiver must be connected to the special "Aux Data Bus" connector on the M1 Control board. This requires an ELKWO35A wiring connector (sold separately). It cannot connect to the M1 data bus or keypad wiring. It NOTE: While the cable assembly is only 18 inches long, it is possible to remote the receiver up to 200 feet away using four conductor wire.


What's Related
These might interest you as well
FAQ

Web Pages